consistency error
英 [kənˈsɪstənsi ˈerə(r)]
美 [kənˈsɪstənsi ˈerər]
网络 一致性误差
双语例句
- When Domino detects an internal consistency error, or a condition that may lead to corruption of data or some other problem, it immediately calls a subroutine called Panic.
当Domino检测到一个内部一致性错误，或者一个可能导致数据破坏或其他问题的条件时，它会立即调用一个名为Panic的子例程。 - An internal consistency error occurred. Contact Technical Support for assistance.
发生内部一致性错误。请与技术支持联系以寻求协助。 - This paper analyzes some problems existing in classification indexing from the aspects of its specificity, scale, coordination, consistency and error ration, and finally puts forward some countermeasures.
摘要从分类标引方法，分类标引专指度、完全度、协调度、一致性和差错率等几个方面叙述了分类标引存在的问题，并提出了改善措施。 - Remote computing system consistency error
远程计算系统的一致性误差 - Series laboratory comparing test was done using the new developed. The result dis-played that mixing instrument could estimate the consistency more exactly and mixing time of slurry mixtures and also could avoid test error of artificial mixing effectively.
采用新研制的拌和试验仪器，进行了系列室内对比试验，结果显示拌和试验仪可以更准确地判断稀浆混合料的稠度和拌和时间，有效地避免人工拌和的试验误差。 - Based on the assumptions of smoothness and consistency in images, the method to confirm the starting position of error is proposed, and the algorithm to detect the non-syntax errors, such as DC coeffi-cient errors, is also presented.
因此，基于图像光滑性和一致性的假设，提出了非语法错误的纹理图像的检测算法（如DC系数的错误检测算法）以及确定错误起始位置的方法。 - We obtain the strong consistency and convergence rate, mean and strong of the integrated absolute error consistency for modified partitioning estimate undera-mixing sample with identically distributed by means of Bernstein inequality for a-mixing sequence.
利用α混合序列的Bemstein不等式，证明了同分布的α混合样本下回归函数改良基于分割估计的强相合性及收敛速度，积分绝对误差的强相合性与平均相合性； - The consistency error is one order higher than that of interpolation error.
即相容误差比插值误差高一阶。 - Based on the additive consistency definition of the grey numbers complementary comparison matrix, the error variables are introduced to express the uncertainty of the decision maker.
基于区间灰数互补判断矩阵的加性一致性定义，引入偏差变量来表达决策者的判断不确定性特点，建立估计群偏好权重的目标规划模型。 - A nonconforming rectangular mixed finite element is proposed, then it is applied to the stationary Stokes. The optimal approximation error and consistency error are obtained.
提出了一个新的矩形非协调混合元格式，把它应用于Stokes问题的数值逼近，得到了最优的误差估计。 - The favorable consistency exists between the experimental data and the fitting curve. The temperature measurement error of the system is about 0.8 C.
该系统实验数据和拟合曲线之间显示了良好的复合性，温度测量误差在0.8℃左右。 - Consistency of Circular Pole and Error Variance Indices in Satisfactory Estimation
满意估计中极点与误差方差指标的相容性 - On r-th mean consistency of regression model estimate under NA error sequences
误差为NA序列的回归模型估计的r阶矩相合性 - The article introduces a method which test and demarcate consistency of multichannel, multi-sensor optic axis and datum line of airborne flat form, designs a equipment to analyze the error.
介绍了一种针对航空机载平台的多波段、多传感器瞄准线（光轴）及其安装基准轴之间一致性进行检测和定量标定的一种方法。 - All judged matrix meet the consistency demand, and the rate of error is less than 0.1.
所得判断矩阵都满足一致性要求，误差均小于0.1。 - It is also proved that this element is superconvergent of order O ( h2) for the biharmonic equation by using a series of novel ideas and techniques. Moreover, the consistency error estimate is obtained on the anisotropic meshes.
对重调和方程通过运用新的方法和技巧，证明了该元具有O（h2）阶的超收敛性质，而且，相容误差的估计是在各向异性网格下得到的。 - Using the method analogous to quasi-Wilson element, we study the nonconforming finite element of five parameters narrow quadrilateral, and prove that this element has a special property, that is, consistency error is one order higher than that of interpolation error.
用类似于类Wilson非协调元的方法还研究了五参数窄边四边形非协调有限元法，证明了该元具有特殊的收敛性质（即相容误差比插值误差高一阶）。 - The Consistency Test and Error Analysis Of Judgement Matrices
判断矩阵的一致性检验与误差分析 - The results show that the consistency of the measurement system is high, and the measurement error does not exceed the scope of system requirements. The system successfully passed the acceptance of Party A.
试验结果表明，测量系统的一致性比较高，测量发射率的结果在要求的误差范围内，顺利通过了甲方的验收。 - The consistency condition is that the absolute value of the error of the Euler approximation is no more than some coefficient times the product of the square of sample period and the norm of states.
本文提出的相容性条件为，闭环Euler近似模犁误差的绝对值不大于某个系数乘以采样周期平方与状态模长的乘积。 - The causes of inconsistencies of simulation models are analyzed, and a consistency analysis method based on graph theoretical algorithms is proposed, which can enhance the error detecting and correcting process.
本文分析了造成仿真模型奇异的原因，提出了基于图论算法的相容性分析方法，显著地提高了奇异模型的识别和修正效率。 - The differential equation consistency between screw compensation algorithm and conventional algorithm is verified. The causes of computation error for the two algorithms are analyzed.
证明了螺旋补偿算法与传统算法在导航微分方程上的一致性，并对两种算法的误差源进行了分析比较。 - According to the consistency of two-phase noises, the noise offset is achieved through the transversal filter based on adaptive least-mean-square error ( LMS) algorithm.
根据两相的噪声一致性特点提出基于自适应最小均方误差（LMS）算法的横向滤波器实现中压电力线通信的噪声对消。 - The simulation results show the result of the Non-dimensional relationship has a good consistency with numerical simulation result, and the max. relative error is 12%.
计算结果表明，本文所得无量纲关系式的计算结果与模拟值基本吻合，最大误差为12%。 - Then by introducing spatial geometric consistency constraints into branch and bound algorithm, the best fragment matching pairs are acquired through the fast and efficiently minimization of distance root mean squared error ( dRMS).
继而在分支界定算法引入空间几何一致性约束，高效快速将距离均方根误差dRMS最小化从而求得碎片的最佳匹配。 - The test results show that the testing signal of SAW device near the center frequency is strongest, and the operating frequency and the design frequency is consistency, in the 10% error range.
测试结果表明：SAW器件测试信号在中心频率附近信号最强，测得的工作频率与设计频率基本保持一致，误差小于10%。 - The dissertation also proposes a new way to make use of local consistency in feature point localization. At last, an empiristic parameters selection solution is proposed to avoiding error caused by discrete scale space.
同时提出利用局部区域一致性的原理进行特征区域的精确定位，最后，对由连续尺度空间转向离散空间中特征检测中的参数选择问题，通过实验给出了经验的参数选择方法。 - Laser detection system error in the measurement and operation process were studied, such as measuring the time delay, different reflectivity material, laser scanning center consistency on the laser ranging error effect on the corresponding analysis.
对激光检测系统在测量和运算过程中的误差进行研究，如测量延迟时间、不同反射率材料、激光扫描中心一致性等因素对激光测距的误差影响进行相应的分析处理。 - We prove the consistency, asymptotic normality and mean squared error of the parameter estimates. Also, under the principle of minimizing mean squared error of the estimates, we provide the strategies for selecting the bandwidth and sample size of augmented data.
我们推导了估计值的相合性，渐近正态性以及均方误差，并在最小化参数估计均方误差的前提下，给出了选取窗宽和扩张数据样本量的建议。